Results 1 to 7 of 7
Thread: Auto back flush
-
13-02-2015, 04:51 PM #1
Auto back flush
Hi all, Im new to RO ...i've brought a 450 gpd system but want to fit a auto back wash ..what size restrictor can i fit ...will a 400gpd be ok this is the largest i can find ? If its not correct please direct me to where i can buy the correct part from . thanks mark
-
14-02-2015, 07:51 PM #2
Hi Mark
I would fit a manual flow restrictor to control the flow as you can fine tune it
Water Flow Control Valve - £10.99 : Water Filter Systems, Pure Water Products
Its 3/8 but he has reducers down from 3/8 to 1/4
Auto flush kit from the same place.
Reverse Osmosis Auto Flush Kit - £34.49 : Water Filter Systems, Pure Water Products
Hope that helps?
Andy
-
14-02-2015, 09:07 PM #3
Hi Andy helps a little I think pure water products web site is down so ill have to source elsewhere ...also I'm sure on his website he states that capillary Valve should be used ...I'm confused. Com! Ended up ordering a 1500 gpd capillary proberly ordered the wrong valve then? What's your thoughts? Thanks for replying Andy.
-
14-02-2015, 09:30 PM #4
Hi Mark
That's what I thought about his website? Those links came off his website tonight!
I would personally use the manual needle valve. All RO units come with the fitted restrictor. I removed one from a friends RO unit last week and fitted the manual one. Much better control and easy to set the pressure to 80-90 psi. As long as you remember that you have to have waste coming out of the RO unit and the combined TDS of the waste coming from the membranes does not exceed 1000ppm you will be fine. 60% pure water to 40% waste is the norm for a RO unit.
Andy
-
14-02-2015, 10:29 PM #5
Cheers Andy ill wait now until all my bits have been delivered and up and running thanks for the heads up, tried to order the ro unit ect and payment wouldn't go through ...received a email later explaining problems there end.
-
11-10-2016, 05:07 PM #6
Hi Andy,
Can you let me know which membranes give a 60/40 product to waste ratio? I'm running Dow Corning ones and they are more like 20/80 at best and I'm on a water meter!
Ta
-
11-10-2016, 10:08 PM #7
I think the ratio of product to waste depends on your source water and water pressure/flow through the membranes, I use the Axeon 150GPD membranes which give me 50/50.
I also use a AO Smith FS-TFC XLE-4040 ultra-low pressure membrane that gives me 75% product 25% waste.
Similar Threads
-
My puddle build
By AdamKoi78 in forum Pond Construction and Pond Build DiariesReplies: 303Last Post: 22-02-2017, 11:11 PM -
whats a URL
By Kindai kev in forum General Koi Carp ChatReplies: 5Last Post: 27-05-2014, 01:53 PM -
90% water loss top up advice please
By Ianb in forum Water Treatment, Protein Skimmers and FiltrationReplies: 12Last Post: 25-01-2014, 02:42 PM -
100 L Fish tank with loads of bits an bobs
By bstro747 in forum Koi and Pond Equipment for SaleReplies: 0Last Post: 01-09-2013, 12:47 PM
Aquaforte Dm vario 20000 pumps
Still for sale. Postage available for cost Sent from my SM-S901B using Tapatalk