Results 1 to 4 of 4
-
04-06-2024, 09:55 AM #1
Yamitsu Algae Master 55w UV water in bulb connectors
Hi all,
I'm new to the forum so bear with me. I've recently replaced the quartz sleeve and UV bulb in my Yamitsu Algae Master 55w UV. It doesn't appear to be working (I cannot see any UV glow at night, which presumably is the only way I can check) and the pond murk is not clearing.
I think some water had gotten into the end connectors, due to the quartz sleeve breaking. Is there a solution to this or will I have to replace the electrics/unit? Would really welcome any advice on this or any other checks I can make.
Thank you.
-
04-06-2024, 01:26 PM #2
If you are OK working with mains voltage and have access to a multimeter, you can check if the bulb connectors are getting power when turned on, but as you have fitted a new quartz and bulb, it's likely that the ballast unit has died, possibly from the water in the end caps, so most likely will need replacing.
A good tip, if you don't know already, for checking the bulb is working - look at the ends through your phone's cameraLatest: Sansai Budo Goromo Yamabuki, Nisai; ShiroUtsuri OchibaShigure,Tosai; Beni Kikokryu,KinMuji
-
04-06-2024, 01:34 PM #3
Thanks for the guidance. I'll do a double check with the phone's camera but I suspect a replacement ballast unit will be necessary.
Appreciate your help, thanks again.
-
11-06-2024, 11:56 PM #4
The replacement ends are about a fiver on eBay if needed. You can buy replacement ballasts very cheaply too
2660 Gallons. 4" Bottom Drain and Skimmer. Draco Solum 16 Drum. Anoxic Filtration. Air lift returns.
-
wilsonmrh8 Thanked / Liked this Post
Filtreau 25 & bio unit
Agreed, as long as it's sterile. get it mature if you have the room, to reduce ammonia spikes when...