Welcome to Koi Forum. Is this your first visit? Register

Search:

Type: Posts; User: voodoo_15_uk

Page 1 of 20 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    9
    Views
    1,215

    I got a couple of 4” ball valves from CW Ponds...

    I got a couple of 4” ball valves from CW Ponds for about £50 each.


    Sent from my iPhone using Tapatalk
  2. Replies
    217
    Views
    11,735

    It wasn’t me who fitted it [emoji57][emoji31] ...

    It wasn’t me who fitted it [emoji57][emoji31]


    Sent from my iPhone using Tapatalk
  3. Replies
    217
    Views
    11,735

    I’ve put a wedge under the lip, seems to have...

    I’ve put a wedge under the lip, seems to have sorted it
    Bloody freezing!


    Sent from my iPhone using Tapatalk
  4. Replies
    217
    Views
    11,735

    Final pond build!

    I only have little fingers [emoji28] is a tight fit when palm down which would be 1cm at a push.

    It’s solvent glued in place so won’t lift.


    Sent from my iPhone using Tapatalk
  5. Replies
    217
    Views
    11,735

    The dent has been repaired but I have come across...

    The dent has been repaired but I have come across another issue that I am hoping is easily solved.

    So the BD dome nearest the window is too low.
    I can only just get one finger under the lip of...
  6. Replies
    217
    Views
    11,735

    Yes tomorrow morning I’ve been told. Was hoping...

    Yes tomorrow morning I’ve been told. Was hoping it would be today but they have been held up on another job.
  7. Replies
    217
    Views
    11,735

    I’ve left about 9” water in the pond so that...

    I’ve left about 9” water in the pond so that should keep it down, I’ve just drained it to just past the dent.
  8. Replies
    217
    Views
    11,735

    Will be a patch job so not take too long. I’ve...

    Will be a patch job so not take too long.
    I’ve lowered the water level to below where it is.
    https://uploads.tapatalk-cdn.com/20231211/c9d6106d5a63be2d432f054620a935b4.jpg...
  9. Replies
    217
    Views
    11,735

    Gutted I’ve just been to check on the pond and...

    Gutted
    I’ve just been to check on the pond and the tarp that was covering it has taken a block with it and that’s gone into the pond leaving a dent that’s gone through the glassing.
    [emoji24]
    ...
  10. Replies
    217
    Views
    11,735

    Well it’s finally happened! We got the...

    Well it’s finally happened!

    We got the glassing done, Nick and Sam were fab despite the odds against them with cold and rain.

    Had a few issues which they promptly and soundly sorted as well...
  11. Replies
    1
    Views
    941

    Price reduced to £1800 Sent from my iPhone...

    Price reduced to £1800


    Sent from my iPhone using Tapatalk
  12. Replies
    2
    Views
    372

    Can you remove the safety switch from the lid and...

    Can you remove the safety switch from the lid and put it on the contact then test the drum to see if it’s turning.

    We have just had to replace our motor as it failed. Water had somehow got into...
  13. Replies
    1
    Views
    941

    Momotaro Bakki Shower and 80kg BHM

    We have our 4 tier Momotaro Bakki Shower for sale with 80kg genuine BHM, weir tray, lid and spray bar.

    Measurements for each tray are 12” high, 14” width and 31” length

    Very good condition ...
  14. Replies
    217
    Views
    11,735

    Haha yeah it’s quite a deep hole. I must say Pops...

    Haha yeah it’s quite a deep hole. I must say Pops has been a god send with his digger. I’d still be digging it out now if doing it by hand and would probably be buried alive in it.
    Seems to...
  15. Replies
    217
    Views
    11,735

    Having big problems with water ingress. Got dad...

    Having big problems with water ingress.
    Got dad to dig a big deep hole so I could sink a bin into it and stick the sump pump in.
    It is deep enough for the float switch to work when there is enough...
  16. Replies
    217
    Views
    11,735

    Unfortunately it was written off. The engine...

    Unfortunately it was written off. The engine pipes and wires completely melted. Lucky it never reached to oil or fuel tank.


    Sent from my iPhone using Tapatalk
  17. Replies
    217
    Views
    11,735

    Aww no, I’m so sorry to hear that, it’s such a...

    Aww no, I’m so sorry to hear that, it’s such a kick in the teeth

    Yeah I did wonder that but my KH is 6 and tested pH on the Hanna (8.0) and 2 different drops tests (7.5-8). I’ve had a trickle...
  18. Replies
    217
    Views
    11,735

    Latest installment uploading right now. Give it...

    Latest installment uploading right now. Give it an hour or so before trying the link

    Project Koi Pond: Part 6
    https://youtu.be/nqaw84H2Aa0

    Also lost another koi 2 days ago. Not a mark on her...
  19. I Can vouch for Ken, and highly recommend him. ...

    I Can vouch for Ken, and highly recommend him.
    He’s fab and we have his team booked in to do our next pond.
  20. Replies
    217
    Views
    11,735

    Also the latest video….. Project Koi pond Part...

    Also the latest video…..

    Project Koi pond Part 5
    https://youtu.be/5woOJd-OUk


    Sent from my iPhone using Tapatalk
  21. Replies
    217
    Views
    11,735

    Bit more progress…. ...

    Bit more progress….

    https://uploads.tapatalk-cdn.com/20231009/a8e43baea1388cd75c96c3c57d1fc8d2.jpg
    https://uploads.tapatalk-cdn.com/20231009/babdb416f073e550f2b7fa83d0e6c920.jpg
    I have left...
  22. Replies
    217
    Views
    11,735

    Oh and we have also found some gorgeous quartz...

    Oh and we have also found some gorgeous quartz cladding that we want to put on the pond sides.
    https://uploads.tapatalk-cdn.com/20231004/f0e6c8e6ce995fa120194cc1d45a56e5.jpg
    The photo doesn’t do it...
  23. Replies
    217
    Views
    11,735

    It’s been a rough season for us all by sounds of...

    It’s been a rough season for us all by sounds of it, sorry to hear of all you guys losses too.
    [emoji22]
    Bit more done yesterday...
  24. Replies
    217
    Views
    11,735

    https://uploads.tapatalk-cdn.com/20230927/8c58ca1e...

    https://uploads.tapatalk-cdn.com/20230927/8c58ca1e570352a0fe162b7068f913d2.jpg

    https://uploads.tapatalk-cdn.com/20230927/debeb46c287b50a134476f18a5e6ba7f.jpg

    Our motor on the drum has packed up...
  25. Replies
    217
    Views
    11,735

    I’m having technical issues getting the latest...

    I’m having technical issues getting the latest episode put together. Keeps crashing.

    Anyway here’s the latest.
    Been getting the return and waste pipes in....
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4
All times are GMT +1. The time now is 04:45 AM. Online Koi Mag Forum
Powered by vBulletin® Version 4.2.3
Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.

vBulletin Improved By vBFoster® (Lite Version), © UltimateScheme, Ltd.